Ball Joint Assemblies can be installed in locations where additional mobility for the conduit is required.

Ball Joint Assemblies are assembled using a gripping clamp and a protector combined with a special middle jaw that allows the protector to swivel inside.

* To create a 29 mm Ball joint assembly a special PAKPB-29 Protector is inserted “directly” into the PASSB-29 Gripping Clamp without the requirement of a separate jaw set.

Ball Joint Jaws

The Ball Joint Jaws attach as part of the Ball Joint Assembly.
Part No. Size Quantity
PA KGB-36 36mm 10
PA KGB-52 52mm 10
PO KGB-70 70mm 10
  • This field is for validation purposes and should be left unchanged.

Ball Joint Protector

The Ball Joint Protector attaches as part of the Ball Joint Assembly.
Part No. Size Quantity
PA KPB-29 29mm 10
PA PRB-36 36mm 10
PA PRB-52 52mm 10
  • This field is for validation purposes and should be left unchanged.