The Connection Joint is used primarily as part of a conduit termination assembly in dynamic applications. The joint has 3 sets of grooves at each end that firmly hold onto the corrugations of the conduit and the corrugations of the cablestar/grommet.

Once loaded into the same size 36, 52 or 70 mm Gripping Clamp the Connection Joint is able to rotate 360° in a radial direction to relieve torsion build-up . The centre of the Connection Joint has a rounded “ball joint” design so that once seated inside the Gripping Clamp the entire Connection Joint is able to tilt +/- 12 degrees.

* Gripping Clamp and/or Cablestar required

Trumpet Ball is similar to the Connection Joint and is used primarily as part of a conduit termination assembly in dynamic applications. The Trumpet Ball joint has 3 sets of grooves at one end that firmly hold onto the corrugations of the conduit and a large opening with smooth radius edges at the other end for the cables and hose to exit the conduit and run to their termination points.

Once loaded into the 70 mm Gripping Clamp the Trumpet Ball Joint is able to rotate 360° in a radial direction to relieve torsion build-up. The centre of the Trumpet Ball Joint has a rounded “ball joint” design so that once seated inside the Gripping Clamp the entire Trumpet Ball Joint is able to tilt +/- 12 degrees.

70mm size only.

* Gripping Clamp and/or Cablestar required

Ball joint assemblies can be installed in locations where additional mobility for the conduit is required. The ball joint assembly will allow for + or – 12° of orbital movement in all directions.

* Gripping Clamp and/or Cablestar required

See the following product pages for details on the individual parts required for this combination:

• Gripping Clamp
• Combi Jaw
• Cablestar

Please fill out the Request for Quote form for more information on this combination.